VANDERHALL VENICE 2017, Руководство пользователя

Страница: 43 / 109

43
Turn and Lane-Change Signals
Move the lever all the way up or down to
signal a turn.
A light on either side of the Vanderhall
Logo in the speedometer will flash in the
direction of the turn or lane change.
Raise or lower the lever until the light
starts to flash to signal a lane change. Hold
it there until the lane change is completed.
If the lever is briefly pressed and released,
the turn signal flashes three times.
The lever returns to its neutral position
when it is released.
If after signaling a turn or lane change the
arrow flashes rapidly or does not come on a
fuse may have failed.
S
EE
F
USES AND
C
IRCUIT
B
REAKERS

76
Turn Signal On Chime
If the turn signal is left on for more than 1.2
km (0.75 mi), a chime will sound at each
flash of the turn signal. To turn the chime
off, move the turn signal lever to the
neutral position.
Lighting Features
Battery Load Management
The vehicle has Electric Power
Management (EPM) that estimates the
battery's temperature and state of charge.
It then adjusts the voltage for best
performance and extended life of the
battery.
When the battery's state of charge is low,
the voltage is raised slightly too quickly
bring the charge back up. When the state of
charge is high, the voltage is lowered
slightly to prevent overcharging.
The battery can be discharged at idle if the
electrical loads are very high. This is true
for all vehicles. This is because the
alternator may not be spinning fast enough
at idle to produce all the power needed for
very high electrical loads.