Vanair Air N Arc All-in-One Power Systems 300, Руководство по эксплуатации и список запасных частей

Страница: 99 / 204

AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 6: MAINTENANCE
090010-OP_r0 PAGE - 81
13. Connect the pneumatic tube [ F ] to the new
valve body.
14. Test the unit to assure that the valve is
working properly.
6.5.9 DRAINING THE AIR TANK
Refer to Figure 6-10 . The air tank reservoir may
accumulate a moisture build-up on the inside due to the
compression of air. The air tank should be checked daily
and allowed to drain by opening the drain cock on the ball
valve located at the lower right corner of the base frame
on the back end of the machine. For areas of high
ambient moisture content the valve may need to be
checked more than once per day. This valve may be
accessed at any time, including while the machine is in
operation.
TOOLS NEEDED
REPLACEMENT
PART(S)
Catch Tray or Cloth to
Absorb Drained Moisture Not Applicable
KEY DESCRIPTION
A DRAIN VALVE
B MACHINE FRAME
C AIR TANK
Figure 6-10: Air Tank Drain
A
B
C
NOTE
If operating the machine in high
humidity, the drain valve can be left
partially open to relieve water build-up
during operation. This water may contain
a small amount of oil.
Auto drain kit is available from Vanair®.
Consult Section A.5 , for order number.
NOTE
The 1/4” NPT fitting at the end of the
drain valve can be piped to a holding
tank.