Vanair Air N Arc All-in-One Power Systems 300, Руководство по эксплуатации и список запасных частей

Страница: 66 / 204

SECTION 5: OPERATION AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 48 090010-OP_r0
engine should start at idle speed the next
time it is started.
5.3 ENGINE THROTTLE CONTROL
FUNCTIONS
The engine speed is controlled by three factors:
1. The level of air pressure in the tank and the
position of the compressor switch.
2. The position of the welder switch on the unit
control panel, and the use of the welder.
3. The position of the generator switch on the
control panel.
Consult Table 5A: Engine Throttle Control Function
Conditions
to understand how the engine speed relates
to the demand(s) of the machine system’s output
functions.
TABLE 5A: ENGINE THROTTLE CONTROL FUNCTION CONDITIONS
I
Pressure Setting Compressor
Switch
Generator
Switch
Welder
Switch
Engine Speed Condition Result
Tank Pressure
Below (<) 100 PSI or
Set Pressure
II
ON OFF OFF Engine runs at full throttle (3600 RPM).
Tank Pressure
Above (>) 100 PSI or
Set Pressure
II
OFF OFF OFF Engine runs at idle speed (1650 RPM),
ready for application.
ON OFF ON Welder can be activated by striking an arc,
and Engine runs at idle speed (1650
RPM), ready for application.
ON ON OFF Engine runs at full throttle speed (3600
RPM); generator is ready for use
III
.
ON ON ON Full throttle and all items available for use.
I
Any combination of the 300 Power System output functions (compressor, generator, welder) used
simultaneously at capacity will have an adverse affect on engine running at full throttle.
II
Factory set pressure: 100 PSI = ON / 125 PSI = OFF
III
Consult Appendix A, Section A.3, Wattage Requirements for Common Receptacle Units for a listing
of wattage requirements of various implements.
NOTE
The amps/volts display will read the set
value for five (5) seconds when the dial is
adjusted, and the actual output value five
(5) seconds after the dial has been
adjusted.