Vanair Air N Arc All-in-One Power Systems 300, Руководство по эксплуатации и список запасных частей

Страница: 195 / 204

AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
APPENDIX B: INSTRUMENT PANEL FUNCTIONS
090010-OP_r0 PAGE - 177
B.4.6 INSTRUMENT PANEL - WELDER CV FUNCTION
B
A
1
2
C
D
WARNING
Welder and DCcircuit
charger are live.
FUNCTION/ACTION SUSTAINED OR RESPONSE CONDITION
1 DC Welder/Charger
switch is in Welder
position
I
A Hour meter constantly displays total hours; fuel level meter con-
tinues to display.
2 Switch for Constant
Current/Constant Volt-
age is in the CV posi-
tion
B
II
The ignition position is ON, with the engine operating in low
idle.
C Volt LED is on; display briefly shows voltage setting requested
from potentiometer ( D
III
), then will show the voltage currently
being used at the attached welder leads.
I
When DC Welder/Charger selector switch is in Welder position, all DC Charger mode controls will be
ignored, and the LEDs will be out.
II
The “On” function for a running system refers to the reverted condition of the ignition switch after the
engine has completed starting, as per Section B.2.4, Key to Run Function .
III
Each time an adjustment is made the display will show the setting briefly for approximately three (3)
seconds, and then return to the usage display.
NOTE: All other LEDs will be off.