Vanair 050518, Руководство по эксплуатации и список запасных частей

Страница: 73 / 210

AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 5: OPERATION
090012-OP_r0 PAGE - 55
5.7.1 CONNECTION - DISCONNECTION SEQUENCE
AND OPERATION
1. With the engine off, insure that the welder, DC
charger switch, and any other engine control
switch are in the
OFF position.
2. Attach the clamps of the battery charge cable
to the battery to be charged. RED to the
positive terminal, BLACK to the negative
terminal (
Figure 5-6 ).
3. Plug the battery charge cables into the battery
cable connection.
4. Start the engine and wait for all indicator lights
to turn off. Place the DC Welder/Charger
selector toggle switch in the
DC Charger
position, and then the DC Charger Mode
switch to the correct position. The engine
should come up to operating speed; the
battery is being charged.
5. When machine begins to cycle between high
and low idle then the battery is fully charged.
6. To disconnect the charging system, place the
DC Welder/Charger selector toggle switch to
the
OFF position.
7. Allow engine to idle down, then shut down the
engine.
8. Now it is safe to disconnect the clamps from
the battery being charged, and the battery
cable connection on the front of the machine.
5.8 EXTREME CONDITION
OPERATION
IMPORTANT
Never attach boost cables to the panel
before attaching to the battery. Always
attach cables to the battery first.
System Component or
Part Group Task
Manual
Section
Location
Extreme Condition Operation
5.8 page 55
Cold Weather Operation 5.8.1 page 56
Engine Operation 5.8.1.1 page 56
Machine Operation 5.8.1.2 page 58
High Temperature Operation 5.8.2 page 58
KEY DESCRIPTION
A BLACK
B RED
Figure 5-6: Battery Cable Connections
A
B
IMPORTANT
Never leave the machine unattended
while charging a battery. Always
carefully monitor the charging system
while it is in use; the high amperage level
that the unit produces can damage the
battery being charged, or the other
components, if the unit is left connected
for an extended period of time.