VAN DER ENDE Verti-Fan EC, Руководство пользователя

Страница: 12 / 28

Page 12 of 28
4.3 Method with the aid of a steel cable
4.3.1 Content of cable installation kit
In the table below and in the installation description is referred to parts in Figure 4.
Table 4 Contents of cable installation kit
4.3.2 Cable installation
•
Choose a suitable location;
o
If possible, follow the included drawings of the installer or manufacturer;
o
Make sure the hose (E) is able to hang down vertically;
o
Ensure that no objects can fall/hang through the grid on the suction side of the fan (A);
o
Make sure that the distance between the fan (A) and any overhead obstacles (e.g.
shade screen) is at least 300 mm;
o
It must not be possible to touch the ventilator without special equipment, such as a
stepladder.
o
Check that the truss is in good condition;
o
Check if there is a socket sufficiently close by;
•
Before the fan can be attached to the truss, the 4 mounting brackets and spacers (B) need to be
attached to the fan (A);
o
Fixate two of the mounting brackets and spacers (B) by means of 2x eye bolt M6 (N),
4x bodywork washer M6 (P) and 4x hexagonal nut M6 (Q). (see figure 5: right side);
o
Fixate two of the mounting brackets and spacers (B) by means of 2x bolt M6x20 (O),
4x bodywork washer M6 (P) and 2x hexagonal nut M6 (Q). (see figure 5: left side);
•
Use proper tools and equipment;
•
Make sure the Verti-Fan can be installed safely, if necessary get help from others;
•
What you will need:
o
Steel cable (R);
o
2x wire clamp (S);
o
2x shrink sleeve (T);
•
Cut the cable (R) to size if necessary, and place some shrink tubing over the ends. Then use heat
to shrink them around the cable ends with the help of e.g. a lighter;
•
Loop the steel cable (R) around or through the truss, and secure with a wire clamp (S). Do this
according to detail view D figure 6;
•
Hang the Verti-Fan to the steel cable (R) such that it hangs on the eye bolts (N) (see figure 4).
•
The positioning of the Verti-Fan is flexible; it can be moved freely along the length of the steel
cable as desired.
•
Finally secure the fan with two wire clamps (B) to hold it in position (see figure 4 t/m 6)
Quantity Description Type
1 Basic package See 4.1
1 Mounting of fan 2x eye bolt M6 x 80 (N)
2x bolt M6x20 (O)
8x bodywork washer M6 (P)
6x hexagonal nut M6 (Q)
1 Mounting to truss beam 8 m stainless steel 3 mm cable (R)
4x wire clamp 3/16” M4 (S)
Piece of 3.2 mm shrink tubing (T)