Valueline VL PPC 6015 VW 10, Руководство пользователя

Страница: 29 / 84

Startup and Operation
2637_en_D PHOENIX CONTACT
3-5
– Duration: This adjusts the time between beeps when Beep On Touch and Beep On
Release are both checked. Move the slider to the left for the beep occur immediately
upon the release. Move the slider to the right for the beep to be delayed to a maximum
of 1 second after the release.
Linearization Style
Normal calibration uses four touch points to calibrate the screen. A greater accuracy of the
calibration can be achieved if more touch points are used in the calibration. Chose a
linearization style of either 9 or 25 points.
To start the linearization function, click the “Tools” tab and then click the “Linearization”
button.
Double Click Time
To adjust the time span that two touches are recognized as a double-click. This range is
approximately 0.25 to 1 second.
Double Click Area
This adjusts the size of the area allowed for the second click relative to the first click.
Mouse modes
Mouse modes allow configuration of mouse (touch) behavior. One of five modes can be
activate (Figure 3-3 shows the button with “Normal Mode” active). The available modes are:
– Normal Mode: emulates normal mouse button behavior
– A touch and release acts as a click and release.
– A touch, drag and release acts as a click, drag and release.
– A constant touch behaves like a mouse button held down. If the Enable Auto Right
Click function is checked, it will act as a right-click.
– Click on Touch: emulates a left mouse button click when the screen is touched
– Click On Release: emulates a left mouse button click when the screen is touched and
released.
– Click On Touch Without Moving cursor: moves the cursor to the touched position and
acts as a normal left click but will not perform a drag to another screen position.
– Click On Release Without Moving cursor: emulates a left mouse button click when a
screen touch is released, but the cursor doesn't move to the touched point until the
touch is released.