Valtra Versu N Series, Руководство оператора

Страница: 96 / 518

2. Press the light panel on/off button to switch on the light panel.
You can turn on the working lights only after you have switched on the light
panel. When the panel is switched on, the symbol on the on/off button is lit
green. Previously saved working light settings are taken into use.
3. Turn the working lights on and off with the corresponding working light
buttons.
When a working light is turned on, the symbol on the working light button is lit
green. The light is lit green even if the actual working light is not installed.
4. Use the automatic rear working lights with the corresponding working light
buttons.
When the automatic operation is activated, the rear working lights are
switched on automatically when the power shuttle lever is in the reverse
position. With the Skyview equipment, the side working lights works alike.
5. Press the light panel on/off button again to switch off the light panel.
The panel can be turned off also by switching off the parking lights. When the
panel is turned off, the working light settings are saved and taken into use
when the panel is turned on again.
NOTE: The rotary beacon light (optional) can be turned on and off from the
light panel independently.
6. Turn the light switch to off position.
3.4.4 Using the cab light
The tractor is equipped with a step light(s) and cab lights.
1
L R
2
GUID-9C953E56-E65D-4C8E-8A16-9A2D354A864F
1. Cab light
2. Cab light switch
The cab lights and step light(s) function automatically as follows:
•
When the door is opened, both the cab and step lights are lit.
• When the door is closed, the lights go out in 10 seconds.
• If the door is left open, the lights go out in 10 minutes.
The cab light switch has three positions: left, centre and right.
3. Operation
- 94 -