Valtra Versu N Series, Руководство оператора

Страница: 130 / 518

1
2
Cruise
2
13.0
1310
13 °C
C3
A5
2
Cruise
P
AUTO 1 B4
ECO
GUID-5C6A2CB4-B70B-4F81-8988-A4DA1EF7D09A
1. Shifting automatics button
2. Selected program
The manual mode is on when the shifting program indicator is not visible.
•
Change between the automatic modes and the manual mode by moving the
gear lever right for automatic and left for manual.
• Press the shifting automatics button to cycle through the Auto1 and Auto2
programs.
Before you can cycle through the programs, you must first activate the
automatics by moving the gear lever to the right (the automatic position).
• In the Auto1 mode, set the desired driving speed with the drive pedal or hand
throttle or by using the driving speed cruise control.
The automatics adjust the engine speed and the correct Powershift gear
according to the driving situation and engine load.
• In the Auto2 mode, set the limits for shifting up and down via the tractor
terminal display.
The automatics change the Powershift gear when the engine speed
increases above or decreases below the set limits.
3.8.11.7 Programming shifting automatics
You can program the shifting automatics to change the Powershift gear on
specific engine speeds.
IMPORTANT: If you engage the driving direction during the programming
sequence, the tractor starts moving. To ensure safety, it is recommended that
you keep the clutch and brake pedals pressed down during the preprogramming.
3. Operation
- 128 -