13
14
4.4 Tyre Rotation
4.4.1 Pay attention to the default installation position of transmitters and ID modules
4.4.2 For example, you need to rotate LFW (left front wheel) /Transmitter A and LRW (left rear
wheel)/Transmitter C.
4.4.3 Interchange ID module A and ID module C
4.4.4 Restart the system (refer to 4.1)
4.5 Replace Transmitter and ID Module
If the transmitter or ID module is out of work, both need to be replaced.
4.5.1 Replace the old transmitter with a new one (for example, transmitter A);
4.5.2 Replace the corresponding ID module with a new one matching the new transmitter.
4.5.3 Restart the system (refer to 4.1)
4.5.4 If necessary, please set the baseline pressure (refer to 4.2.3).
4.6 ID Module Checkout
If you see one or more dashes
“---” on the display, ID module may not be properly plugged into the display.
You need to do ID module checkout.
4.6.1 Long press the front key button on the display for 8 seconds until hearing the
“beep” sound. The
display will show ID module code by four screens. The screen will show 2-digit each time. Short press the
front key button to switch.
The following pictures are for your reference.
eg: ID module code corresponding to LFW is 01012bA8
4.6.2 If the 8-digit ID number shown on the display doesn't match the corresponding 8-digit ID number
on the ID module, pull out the ID module and put it back properly (refer to 4.3).
4.6.3 Press and hold the button for another 8 seconds and the system will resume normal working mode.
Note
：
When the backlight goes out
，
screen will return to pressure interface.
0
0
Psi
Psi
A
B
C
D