11
12
PART FOUR OPERATION PROCEDURE
4.1 Restart the System
The system has to be restarted to re-identify the ID module in the following situations:
①
Tyre rotation;
4.2.3 If the baseline pressure
doesn’t accord with your tyre’s standard cold inflation pressure, you need
to reset. The following procedures are for your reference to re-set baseline pressure.
1. Inflate your
tyres’ pressures to standard cold inflation pressure (such as 50 psi).
②
Replace transmitter & ID module;
Restart Key
*You can find the figures on car
manufacturer’s placard which typically locate on:
To restart the system, please turn off the system and then turn it on again.
4.2 Setting Baseline Pressure
Note: For TPMS201DX, customer could set the baseline pressure according to different vehicles. The
system will give Low Pressure Warning when current pressure is 20% decrease from baseline pressure
and High Pressure Warning when current pressure is 30% increase from baseline pressure.
Note
：
Before setting baseline pressure, please inflate your
tyres’ pressure up to standard cold inflation
pressure.
4.2.1 Set key: on the back of display.
SET key
4.2.2 Short press SET key, then you can query the current baseline pressure.
①
If the display shows
“AAA”, that’s the default set. It is for vehicles with standard cold inflation
pressure in 2~2.5 Bar.
Note:When the pressure is below 1.6 bar,low pressure warning;when the pressure exceeds 3.2
bar,high pressure warning.
②
If the display shows numbers, along with pressure unit, the number will be the current baseline
pressure.
①
the inside of the
drivers’ side doorframe or doorpost
②
the inside of the fuel tank lid/trunk lid
③
glove-box door
2. Press the SET key for eight seconds until hearing the "beep" sound to enter baseline pressure setting.
3. Wait for 2minutes
；
or run your vehicle (refer to 2.6)
；
the new tyre pressure received is new baseline
pressure.
Note: Long press SET key and front key button, then the system will restore default set ---
“AAA”mode.
4.3 Mounting and Dismounting of ID Module
Firmly press the holding key on the back of display when pulling out and plugging into ID module. Pay
attention to the matching of needle plugs and sockets.
Holding Key
