Valor Retrofire F24BN, Инструкция по установке и эксплуатации

Страница: 18 / 26

18
Owner’s Information
Batteries Replacement
All appliances use four 1.5 V AA alkaline batteries for
remote control receivers and the handset uses a 9 V
alkaline battery.
Batteries are accessible by removing the lid of the
remote control receiver. Batteries should last one to
two seasons, depending on usage. Removing batteries
in the off season will extend battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve.
Servicing
If your appliance needs to be serviced, contact your
supplier quoting the model number. It will be helpful if
the appliance serial number can also be quoted. This is
on the rating plate, which is attached to the unit.
The repair parts are shown in the repair parts list.
Please always quote the part number and description
when requesting spare parts.
Vent Safety Switch
This appliance is equipped with a vent safety switch
which, when activated, will turn off the burner and
pilot if the vent is blocked, disconnected, or if there is
excessive down draught.
If the safety switch is activated, wait for it to cool off
before trying to light the appliance again. The safety
switch will cool off and reset itself automatically after 25
to 30 minutes.
In the event that the safety switch is activated
again, contact a qualified service technician for
inspection.
Should the safety switch require replacement, only use
parts supplied by Miles Industries.
CAUTION
DO NOT USE a screwdriver or other metallic object
to remove the batteries from the receiver or the
handset! This could cause a short circuit to the
receiver.
Remote Control Operation
Your fireplace remote control helps you get the comfort, convenience and aesthetics
you want from your gas fireplace. The remote controls your fireplace in different
ways.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings
of time, temperature and automatic ON/OFF can only be programmed when the
function display is flashing . Be patient when programming as it can take a few
seconds to set.
Setting the time
The first thing to do is to set the time.
1. With your thumb, hold down
both the AUTO and TIMER buttons until F flashes.
Let go.
2. Note the digital clock on the bottom right hand corner. The ▲ button sets the
hour; the ▼ button sets the minutes. Set the time.
Note: You must start setting the time while the F is flashing. If it stops flashing,
go back to 1.
3. The display shows °C/24-hour or °F/12-hour. To change the temperature/hour
display, press on the AUTO button while the display flashes.
4. Let go and wait until the flashing stops. The remote shows the time you set. It
also shows the current temperature.