Valor Heating Equinox 754, Руководство по установке

Страница: 38 / 42

Check that the appliance is clean and that
soot or debris is not blocking the gaps
between the ceramic fuel effect pieces causing
an imperfect flame.
Check that soot or debris is not impairing
the electrode spark or pilot burner.
Check that soot or debris is not blocking
any of the holes in the main burner.
After servicing, make sure that the
ceramic fuel effect pieces are replaced
correctly as described in the installation
instructions.
Always test for gas soundness and
spillage after servicing the appliance.
16.1 To Remove the Fire Front
Surround
1. Remove the upper surround trim,
lower surround trim and side surround
trims. These are held by magnets.
2. The surround is held in place by four
retaining plates at the back of the
surround. These slot into four retaining
brackets on the hotbox. To remove the
surround, hold the sides of the
surround and lift upward and forward.
The surround should lift clear of the
hotbox (See figure 40)
3. Replace the surround and trims as in
section 12.
16.2 To Remove the Burner Unit
1. Remove the Firefront surround as in
Section 16.1.
2. Remove the ceramic fuel effect pieces.
3. Detach the spillage plate from the
hotbox by removing the four screws (See
Page 38
INSTALLER GUIDE
Figure 42. Removal of Inner reflector
Figure 41. Spillage plate removal
Figure 40. Front surround removal