Valloy Incorporation.
Any-002
User Manual
any-002
© 2015 Valloy Inc. All rights reserved.
Rev 1.0
– 2015.10
30 of 68
- At this time, press the SET button
one time to save the sensing value,
then sensor tuning is complete.
4.
- To check the sensor tuning
normally, when you move the media
to up and down if the sensor is on
the black mark, the right LED will be
on. Also you have to check if the
sensor is on the label, the LED is off
or not.
2-1.3 How to use cutter
- There is a button of CUTTER&SENSOR Module as shown in the picture below.
- This button is cut button and it works by double pressing.
※ If the cutter is working under the media is already installed, to remove the piece of cut media
is hard. So the cutter is not working by one click.
