VALLEY FORGE & BOLT MANUFACTURING COMPANY
PHONE: (602) 269 - 5748
4410 W. Jefferson St. • Phoenix, AZ 85043 • USA
WEB: www.vfbolts.com
SPC4™ SYSTEM • MODEL 406A • USER’S MANUAL
Rev. 1.0
- Page 15 of 21 -
[4]
Reattach the battery compartment cover.
[6]
On a mobile device with Bluetooth capability such as a smart phone or tablet, enable Bluetooth.
[7]
Begin searching for Bluetooth devices and find the device named “SPC4_M406A”
[8]
Select the device and press pair. Enter the pairing code “4410”. The mobile device and 406A unit
are now paired.
NOTE:
There is
NO
change in the
“LINK”
LED at this time.
[9]
On a mobile device open up a Bluetooth serial monitor of your choosing.
NOTE:
A “Bluetooth serial monitor” app can be downloaded onto a smart device via the Appstore.
Valley Forge does not endorse any particular app.
[10]
With the Bluetooth serial monitor app open, establish a connection to the SPC4_M406A. Tweak
the Bluetooth data settings to match the Bluetooth settings found in
[11]
Data can now be monitored remotely from a smart device.
2.4.0
System Calibration
[1] Locate the Calibration Gage
. This gage is calibrated at VFB that enables a field check to verify
that the 406A unit is properly calibrated by reading 0% “000” and 100% “100” (within ±5%).
[2]
Verify the 406A unit is reading 0% “000” (within ±5%).
1.
Turn on the 406A unit.
2.
Attach the 406A unit to the supplied calibration gage at the end marked “0%”.
3.
Verify that LCD is reading “000” (within ±5%).
Figure 16 - LCD 0%
4.
If the LCD is not reading “000” then an adjustment must be made by accessing the
battery compartment.
5.
First, remove the protective cover.
6.
Adjust the “OFFSET” dial until the LCD reads “000”.
7.
Attach and remove the calibration gage several times to ensure the integrity of the
“000” reading which verifies that the 0% measurement has been calibrated correctly.
Содержание SPC4 406A
Страница 2: ......
