Valhalla Zeus, Руководство пользователя

Страница: 7 / 28

The PIDTuning app is only available on Windows. Although this program makes it
easier to tune the board PID parameters a standard serial console application may be
used on other platforms (e.g. Mac/Linux) for board configuration. Mac users may
need to install drivers to interface correctly with the Zeus – consult section 4
2.2.4 A full list of all the menu options and the default values has been
provided in section 3
Error! Reference source not found. -
introduction
The PIDTuning app is only available on Windows. Although this program makes it
easier to tune the board PID parameters a standard serial console application may be
used on other platforms (e.g. Mac/Linux) for board configuration. The board is
already pre-configured for LP12 users.
2.2.5 Setup Menu - item entry
When in each of the menu items you will be asked to respond to a question. For
example: “Enter 33.3 rpm frequency, Hz: (45 – 65): 50.0”. The question will be
followed by the units, the range of acceptable values in between the brackets (45 -
65), and finally the current value: 50.0. Either provide a new value within the range
specified or press the Return key (CR) to accept the current value. The section
questions will repeat until the Q key is pressed. The Q key can pre pressed at any
time, not just at the end of a section to exit the current setup menu. You must be back
at the main menu to save any settings to the EEPROM.
2.3 Mounting the platter internal IR sensor
– LP12
For Linn LP12 turntables (or turntables with a large space under the platter) an
internal platter IR sensor mounting position is available. Route the 4 way FFC
connecting cable through the central bearing hole (or other available access point).
However, ensure there are no sharp edges to damage the insulation of the FFC cable.
Often the bearing bolt heads have sharp edges so endure the FFC cables are routed in
the spaces between the bolt heads.