Valhalla
V1 series Users Manual
Important!
1. The Valhalla is designed to push cartridges, not to run empty. Do not leave the machine
running without a cartridge installed except for quick cartridge changes. Over time this will
produce a very distinct form of damage which is not covered under warranty.
2. Do not allow cleaning fluids to enter the machine either by spraying or by wiping with an
excessively wet wipe. The four points of entry are the two o-ring grooves on either side of
the stroke adjustment ring, the RCA connector and the plunger bar hole in the end of the
machine.
3. When cleaning the Clean Cap cavity you must be certain that you do not use too much
disinfectant on the swab. Before you clean the cavity you should wet the swab, then dab it
on a piece of paper towel to soak up the excess so that it is only damp, not wet.
4. Do not clean the machine while it’s running.
5. Never lubricate the machine. Damages due to lubrication are not covered by warranty.
The only thing you may want to do (your preference) is dab a little oil/grease/ointment on
the O-ring that provides spin resistance for the grip, but this also is not necessary.
6. Never operate without the protective O-rings found to either side of the stroke
adjustment ring. They serve to stabilize and dampen unnecessary movement and most
importantly, they keep the inside of your machine clean.
--------------------------------------------------------
Voltage
Under most circumstances you will never need to go lower than 6 volts or higher than 11 volts. Its best
for the machine to stay within this range.
Lower voltage = Softer hit AND fewer punctures per second
Higher voltage = Harder hit AND more punctures per second
Stroke Adjustment
The Valhalla has 5 strokes to choose from: 2.5mm, 2.9mm, 3.4mm, 3.8mm and 4.2mm. Simply twist the
ring to select.
Shorter stroke = Softer hit
Longer stroke = Harder hit
Putting it all Together
If you like your speed but need more hit, switch to a longer stroke.
