Valeo THERMO DC 200, Инструкция по установке и эксплуатации

Страница: 6 / 40

2
Statutory regulations governing installation Thermo DC 200
Applicable local regulations, laws and standards for electrical in-
stallations, in particular the provisions of ECE Regulation R100 are
to be observed by the vehicle manufacturer and should be appro-
priately implemented.
ATTENTION:
Failure to follow the installation instructions and the notes contai-
ned therein will lead to all liability being refused by Valeo. The
same applies if repairs are carried out incorrectly or with the use of
parts other than genuine spare parts. This results to the invalida-
tion of the type approval of the heater.
1.2. Model plate
The model plate must be protected from damage and must be clearly
legible when the heater is installed (otherwise a duplicate model plate
must be used).
NOTE: The year of the initial operation must be durably marked by
removing the year numbers that are not applicable.
Danger to life and health!
Warning!
Figure 1: Model plate (example)
Thermo DC
0 Hz / 30A
690 VDC / 20kW