Valcourt Waterloo, Инструкция по установке и эксплуатации

Страница: 9 / 88

FP15 & FP15A Waterloo - Installation and Operation Manual
9
2 GENERAL INFORMATION
2.1 Appliance performance (1)
Fuel type Dry cordwood
Recommended heating area
[*]
1,000 to 2,800 ft
2
(93 to 260 m
2
)
Firebox volume 4,28 ft 3 (0,113 m 3 )
Maximum burn time
[*]
10 h
Maximum heat output (2) (dry cordwood) 95 000 BTU/h
Overall heat output rate (min. to max.) (2)(3)
16,610 BTU/h to 43,021 BTU/h
(4,9 kW to 12,6 kW)
Average overall efficiency
(3)
- Dry cordwood 63.9% (HHV
(4)
) 68.4% (LHV
(5)
)
Optimum efficiency (2)(6) 69.7%
Average particulate emissions rate
(7)
1.6 g/h (EPA)
Average CO (8) 157.4 g/h
[*]
Recommended heating area and maximum burn time may vary subject to location in home, chimney draft, heat
loss factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined
by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case
of a power failure.
(1)
Values are as measured per test method, except for the recommended heating area, firebox volume, maximum
burn time and maximum heat output.
(2)
The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft
3
and 20 lb/ft
3
.
Other performances are based on a fuel load prescribed by the standard. The specified loading density varies
between 7 lb/ft
3
and 12 lb/ft
3
. The moisture content is between 19% and 25%.
(3)
As measured per CSA B415.1-10 stack loss method.
(4)
Higher Heating Value of the fuel.
(5)
Lower Heating Value of the fuel.
(6)
Optimum overall efficiency at a specific burn rate (LHV).
(7)
This appliance is officially tested and certified by an independent agency.
(8)
Carbon monoxide.