background image

VALCOM ONE-WAY AMPLIFIED TRACK STYLE SPEAKERS 

 

Valcom Track Style Speakers, V-1013B (one-watt) and V-1014B (five-watt), are weather 
resistant, self-amplified and provide voice paging as well as background music. These 
speakers have externally accessible volume controls that are adjustable by a 
screwdriver through the hole in the grille and are available in white, black and gray. 

Model V-1013B-W 

 

White 

Model V-1014B-W 

Model V-1013B-BK 

 

Black 

Model V-1014B-BK 

Model V-1013B-GY 

Gray 

Model V-1014B-GY

 

 

DIMENSIONS/WEIGHT 

• 

V-1013B-

 5.80” Dia. x 8.80” H (14.73cm Dia. x 22.35cm H) 

• 

2.5 lbs. (1.13kg) 

• 

V-1014B-

 5.80” Dia. x 8.80” H (14.73cm Dia. x 22.35cm H) 

• 

3.1 lbs. (1.41kg) 

 

The V-1013B requires -24VDC, 50mA (1 Valcom Power Unit) and the 
V-1014B requires -24VDC, 300mA (6 Power Units).  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

Note:    DO NOT connect this speaker directly to a 25/70/100 Volt amplifier 

as damage to both the amplifier and speaker may occur.

 

 

INSTALLATION 

1.    Mount the bracket. 
2. 

Remove knobs and mount speaker to bracket. 

3. 

Attach knobs and position at the desired angle. Tighten knobs (See Figure 1).  
Typical coverage of thes e speakers is 600 square feet with good quality paging 
heard up to thirty feet in front of the speaker.  Speakers should be spaced 
approximately twenty feet apart.  The five-watt version is recommended for 
higher noise level areas. 

 

CONNECTIONS 

 
 
 
 

 
 
 
 
 
 
 

Recommended Quantity of Speakers per Specific Power Run 

 

Speakers per Power Run 

Wire Run Length (Feet) 

V-1013B 

V-1014B 

24AWG 

22AWG 

15 




250 
500 

1000 

400 
800 

1600 

 
TROUBLESHOOTING CHART 

 

SYMPTOMS 

ACTIONS 

No audio from 
speaker 
 
 
Low volume from 
speaker 
 
 
 
 
 
            Loud squeal     
          (feedback) 

1. 

Verify volume control is turned up (clockwise). 

2. 

Using a lineman's test set, check for proper audio 
level at Tip and Ring leads and if necessary at the 
source. 

1. 

Verify volume control is turned up. 

2. 

Check voltage at the speaker when in use,  (-18 to  -
24VDC required). 

3. 

Using a lineman's test set, check for proper audio 
level on Tip and Ring leads.  It is possible that 
some low, level audio will be heard with only one 
side of Tip and Ring connected. 

1. 

Decrease volume of speaker (counterclockwise). 

2. 

Increase the distance between telephone and 
speaker. 

3. 

Install confidencer on the telephone in severe 
problem areas. 

 

Knob

Mounting
Bracket

FIGURE 1

Volume
Control

(Tip/A) Green
(Ring/B) Red

(-24VDC) White
(GND) Black

One-Way
Amplified
Speaker

Page
Out

Valcom Page

Control

Valcom -24VDC
 Power Supply

FIGURE 2

Отзывы: