Valco Cincinnati VC350A, Руководство пользователя

Страница: 13 / 327

Valco Cincinnati 3-1
Section 3—General Wiring Guidelines
Routing Low-Voltage Leads
When routing low-voltage leads, follow these guidelines:
• Do not route low-voltage leads in the same conduit as wires carrying a high-current load.
• Do not route low-voltage leads adjacent to, or across wires carrying a high-current load. If low-voltage
leads must cross or run parallel to wires carrying high current, keep the leads at least 6" (152 mm) from
high-current wires.
• Do not splice or solder leads.
• Trim leads to the required length. Leads should be only as long as necessary for installation.
• All wiring should be in conduits or wireways.
Connecting the Supply of Electrical Power
WARNING! Electrical connections should be made only by experienced
service personnel! OTHERWISE, DEATH, PERSONAL INJURY, OR EQUIP-
MENT DAMAGE COULD OCCUR.
When connecting the supply of electrical power, follow these guidelines:
• Connect the control to a “clean” supply of electrical power. Use a dedicated circuit if possible.
Note! If a dedicated circuit is not available, do not connect the control to a circuit that supplies high-
amperage equipment—use another circuit such as a lighting circuit. Otherwise, equipment may not
function properly.
WARNING! Electrical installation should be accomplished only by experi-
enced service personnel! OTHERWISE, DEATH, PERSONAL INJURY, OR
EQUIPMENT DAMAGE COULD OCCUR.