Configure Logger
Connectivity
1. Run the
Device Setup Wizard
(on the Vaisala Veriteq Device Drivers CD).
2. Identify your Device using the MAC address
,
found on the side o
r bottom of the
Device.
3. Enter an IP address (provided by your IT department).
4. Select RealPort settings, and
choose to install the RealPort for your Device.
5. Complete the Wizard accepting all remaining default options.
To configure HMT140 Device connectivity:
1. Run the
HMT140 Utility
(installation CD).
2. Connect the HMT140 Configuration Cable to the 4-pin HMT140 CONFIG header.
3. On the
HMT140 Utility Setup
tab, click
Retrieve
. To make configuration changes, refer to
the
HMT140 Wi-Fi Data Logger User’s Guide.
4. Disconnect the Configuration Cable from the Device, wait 8 seconds, then press the
SERVICE button.
Configure viewLinc
1.
On your viewLinc Server desktop, click the desktop icon, .
2.
Log in with username:
admin
and password:
admin
.
3.
Complete the Setup Roadmap:
For complete installation and configuration instructions, refer to the
viewLinc User’s Guide.
www.vaisala.com
3
4
4
3
2
1
5
To configure
connectivity for
Loggers using vNet or Digi Devices:
Note: viewLinc Aware configures Logger connectivity automatically (vNet Devices with
s/n
1411xxxx
or
Firmware v1.4
,
or higher). For more information, refer to the
vNet User’s Guide
.
