VADDIO RoboTRAK, Руководство по установке

Страница: 22 / 28

Powering Up the Cameras
Connect camera power.
The cameras will wake up and initialize. This will take a few seconds. When the cameras are ready to
accept control information, their front indicators are blue. At this point, the system is ready to configure.
Operation, Storage, and Care
For smears or smudges on any component of the system, wipe with a clean, soft cloth. Use a lens cleaner
on the lens. Do not use any abrasive chemicals.
Keep this system away from food and liquids.
Do not operate or store the device under any of the following conditions:
n
Temperatures above 40°C (104°F) or below 0°C (32°F)
n
High humidity, condensing or wet environments
n
Inclement weather
n
Severe vibration
n
Dry environments with an excess of static discharge
n
Outside a spacecraft during or after launch
Do not attempt to take any component of this system apart. There are no user-serviceable parts inside.
Next Steps
The camera is now ready to configure and use. This information is available in the Configuration and
Administration Guide for the RoboTRAK Presenter Tracking System . It is also included in the
Integrator's Complete Guide to the RoboTRAK Presenter Tracking System .
19
Installation Guide for the RoboTRAK Presenter Tracking System