VADDIO RoboTRAK, Руководство по установке

Страница: 19 / 28

Installing the Camera Mount
The dual camera mount can be attached to a wall, or mounted to the ceiling.
Wall Installation
Note
You can install the camera mount to a 2-gang wall box or directly to the drywall. If you install the wall mount
on drywall, use the wall anchors provided with the wall mount. If you install it over a wall box, use the cover
plate screws supplied with the wall box.
1. Route cables through the appropriate cable opening in the mount.
2. Attach the mount to the wall, using wall anchors if not attaching it to a wall box.
3. Level the mount and tighten the mounting screws.
4. Check the level again.
Ceiling Installation
For a ceiling installation, you will need Vaddio's Offset Drop-down Ceiling Mount for RoboTRAK, part
number 535-2000-045.
Vaddio does not recommend using a non-offset ceiling mount pole, as the system's center of mass is
significantly forward of the 1" NPT threaded nut. Contact Vaddio if you don't have a suitable ceiling mount
kit.
1. Install the ceiling mount kit according to the instructions provided with it.
2. At the appropriate step, route the cables for both cameras through the pipe.
3. At the appropriate step, attach the dual camera mount to the end of the threaded pipe.
Note
Inverted operation is not supported.
16
Installation Guide for the RoboTRAK Presenter Tracking System