VADDIO RoboTRAK, Руководство по установке, Страница: 18 / 28

Placing the PoE Splitter
Both connections to the IR camera are from the PoE splitter.
Note
If you receive a black and white cable packaged in the box with the splitter,
please discard it. The black and white cable cannot be used with the camera.
1. Remove the backing from one side of the rectangle of 3M
®
Dual Lock™
material to expose the adhesive, and press it firmly against the back of the
PoE splitter.
2. Connect the long Cat-5e cable to the Power & Data connector on the PoE splitter.
3. Connect the short Cat-5e cable to the Data Out connector on the PoE splitter.
4. On the short power cable, identify the connector with no center
pin and connect it to the PoE splitter.
Caution
The connectors on the short power cable are NOT identical.
One has a center pin. Attempting to connect the wrong end of
the cable to the PoE splitter will damage the connector. (We did
this in the lab, and we're admitting it so you can avoid our mistake.)
5. Holding the PoE splitter under the top shelf of the camera mount, route the two short cables through the
cable opening for the upper camera.
6. Determine the best position for the PoE splitter, then remove the backing from the exposed side of the
3M Dual Lock material and press the PoE splitter into place within the camera mounting shelf.
15
Installation Guide for the RoboTRAK Presenter Tracking System