Installing the Quick-Connect Device
If you are installing the camera with a Universal CCU or other Quick-Connect device, mount the Quick-
Connect device appropriately. Follow the instructions provided with the mounting solution.
n
The Universal CCU may be mounted in a rack using the rack mounting brackets provided.
n
The Quick-Connect SR may be mounted directly to the camera wall mount.
n
Rack mounting brackets and under-table mounting brackets are available for the Quick-Connect USB.
n
Rack mounting brackets are available for the other Quick-Connect devices.
Contact us if you don't have the mount you need.
Powering Up the Camera
Connect power to the device that powers the camera – Universal CCU, Quick-Connect device, or AV
Bridge MATRIX PRO. The device and the camera will initialize. This will take a few seconds. When the
camera is initialized and ready, its front indicator is blue. At this point, it is ready to accept control
information.
Note
Wait until the camera finishes initializing before trying to control it using the IR remote or other command
input.
Status Light
The light in the camera's base indicates its current state.
n
Blue:
Normal operation (blinks once when the camera receives a command from the remote)
n
Red:
On-air tally (signal provided by external device via serial connection)
n
Blinking red:
Video is muted (UC color scheme only)
n
Purple:
In standby mode or booting
n
Yellow:
Firmware update in progress
Caution
Do not remove power or reset the camera while the indicator is yellow, showing a firmware update in
progress. Interrupting a firmware update can make the camera unusable.
Note
By default, the camera's status light is active during normal operation; however, it can be configured to
remain off when the camera is powered up. The camera may be sending video even if the indicator light is
off.
38
Complete Manual for RoboSHOT CAT-5 Professional PTZ Camera Systems
