Basic Connections: RoboSHOT QSR System
The Quick-Connect SR interface provides power and control to the camera, and a YPbPr (analog
component video) output. External control is via an RS-232 connected device.
If using the IR FORWARD connector:
n
Use the MOD and GND pins (1 and 2) for balanced (differential) IR. Because it is a differential signal,
you can swap the two wires.
n
Use the GND and NON-MOD pins (2 and 3) for unbalanced (single-ended) IR, for example if connecting
to Polycom equipment. Because it is not a differential signal, pin 2 must go to the GND connection at
the other end of the cable.
This diagram shows a RoboSHOT 12 camera. The RoboSHOT 30camera connects in the same way. The
Quick-Connect SR has been discontinued and is not available for the RoboSHOT 12E CAT-5 and
RoboSHOT 30E CAT-5 cameras.
Basic Connections: RoboSHOT AVBMP
RoboSHOT AVBMP cameras ship with a remote and a wall mount. Connect the camera to an AV Bridge
MATRIX PRO for power, control, and connectivity. Up to three cameras can be connected at once.
This diagram shows a RoboSHOT 12 camera. The RoboSHOT 30, RoboSHOT 12E CAT-5, and
RoboSHOT 30E CAT-5 connect in the same way.
36
Complete Manual for RoboSHOT CAT-5 Professional PTZ Camera Systems
