Back of the Camera – RoboSHOT 12 and RoboSHOT 30
Rear panel connections are identical for the older RoboSHOT 12 and RoboSHOT 30 cameras.
n
Network Control:
RJ-45 connector. Connect to the network for control via the web interface or Telnet
session.
n
HD Video Select:
Rotary switch to select the video output resolution. See
n
Camera Settings:
DIP switches to set camera behaviors such as IR remote frequency, baud rate and
image flip. See
Camera Behavior Settings – RoboSHOT 12 and 30
for more information.
n
RS-232:
RJ-45 connector. Connect to the RS-232 port (if any) on the Quick-Connect device to allow an
external device to manage the camera using a modified VISCA protocol. See
for RS-232 settings.
n
EZPower Video:
RJ-45 connector. Supplies power to the camera and delivers HD video back to the
Quick-Connect interface using high speed differential signaling over Cat-5e cable. Connect to the
EZPower Video port on the Quick-Connect device. (Color-coded orange or yellow, depending on the
device.)
n
36 VDC FOR CCU ONLY:
RJ-45 connector. Power from the Quick-Connect Universal CCU, in
RoboSHOT QCCU systems only.
Do not use this port
except when connecting to a Quick-Connect
Universal CCU.
Note
A label on the bottom of the camera lists the rotary and DIP switch settings.
16
Complete Manual for RoboSHOT CAT-5 Professional PTZ Camera Systems
