Connecting a Vaddio HDBaseT Camera
999-9595-000/001/009
In this diagram, the OneLINK Bridge extends network connectivity, power, and control to a RoboSHOT 12
HDBT camera, and brings HDMI video from the camera to a display. The OneLINK Bridge also provides
audio connections, and can originate a USB stream to bridge non-USB equipment into a USB-based
conferencing application.
Items in this diagram:
n
OneLINK BridgeAV interface
n
RoboSHOT 12 HDBT camera (not included in kit 999-9595-000/001/009)
n
HDMI display and HDMI cable (not included)
n
Laptop using soft conferencing client (not included)
n
USB 3.0 cable to laptop
n
Audio cables (not included) terminated with supplied connectors
n
Connections to microphones and speakers (not included)
n
Cat-5e cables for OneLINK and network connections (not included)
RoboSHOT HDBT Camera
Other Vaddio HDBaseT cameras connect in the same way.
Camera Configuration
You can configure the following settings on your Vaddio HDBaseT camera:
n
HDMI output resolution: Depending on the camera, set this using the rotary switch on the back of the
camera or the virtual rotary switch on DIP Switches tab of the System page.
n
IP streaming: Streaming page. Settings include Enable/disable, streaming quality, and streaming
resolution.
Point the remote at the camera and press the Data Screen button to see the camera's IP address on the
connected display.
No additional configuration is required.
13
Installation Guide for the OneLINK Bridge AV Interface
