Visual Conventions for Connection Diagrams
The following sections provide representative connection diagrams for the various OneLINK kit and system
configurations available. All diagrams in this guide use these visual conventions for connection type.
Connections for HDBaseT Cameras
In this configuration, the OneLINK Bridge extends network connectivity, power, and control to an
HDBaseT camera, and brings HDMI video from the camera to a display. The camera can optionally be
controlled by a camera controller on an RS-232 serial connection to the OneLINK Bridge or over the
network, depending on the controller. The OneLINK Bridge also provides connections for microphones and
speakers, and can originate a USB stream to bridge the non-USB camera and audio equipment into a USB-
based conferencing application.
If an IP stream is available from the camera, the OneLINK device passes it to the network. IP streaming
resolutions up to 2160p/30 are supported. HDMI output resolution and streaming parameters (including
resolution) are configured on the camera, not the OneLINK device.
Kits and Systems for HDBaseT Cameras
This block diagram applies to:
n
OneLINK Bridge for Vaddio HDBT Cameras, 999-9595-000/001/009 – compatible with all Vaddio
HDBaseT cameras.
n
RoboSHOT 12 HDBT OneLINK Bridge System, 999-9960-200/201/209
n
RoboSHOT 30 HDBT OneLINK Bridge System, 999-9963-200/200W/201/201W/209/209W
n
RoboSHOT 20 UHD OneLINK Bridge System, 999-9950-200/200W/201/201W/209/209W
n
DocCAM 20 HDBT OneLINK Bridge System, 999-9968-300/301/309
n
Future systems consisting of a Vaddio HDBaseT camera and a OneLINK Bridge AV interface
12
Installation Guide for the OneLINK Bridge AV Interface
