Setting Other System Behaviors
S
YSTEM PAGE
, G
ENERAL TAB
The following settings are available on the System page:
n
Auto Standby
– Enable to automatically set the camera in standby (low-power) mode when not
connected to a computer.
n
LED On
– Normally on. If desired, the indicator light can be turned off.
n
LED On in Standby
– Normally on. Disable to turn off the indicator light when the camera is in standby
mode.
n
Anti-flicker Filter
– You may need to use this setting if AC mains power is 50 Hz.
Note
By default, the camera's status indicator light is active during normal operation; however, it can be
configured to remain off when the camera is powered up. The camera may be sending video even if the light
is off.
31
Complete Manual for the HuddleSHOT All-in-One Conferencing Camera