Initial Device Set-Up Using the Vaddio Deployment Tool
Be sure you have the current version of the Vaddio Deployment Tool. This tool is available as a free
download at
https://info.legrandav.com/VaddioDeploymentTool
. If you have a copy of the tool already,
compare its version information to the version shown on the release notes. You can find this document at
https://www.legrandav.com/en/products/vaddio/accessories/vaddio_deployment_tool
under the
Resources tab.
To complete the initial device set-up with the Vaddio Deployment Tool:
1. Download and install the Vaddio Deployment Tool if you have not done so already, then open it.
2. Power up the EasyIPsystem if you have not done so already.
3. On the Find Devices page, click Scan. If the scan does not locate the EasyIP devices, click Advanced
and specify the appropriate portion of the network to scan – your computer may be on a different subnet
from the EasyIPEasyIP equipment.
Pro tip
On the Groups page of the Vaddio Deployment Tool, you can create a group containing only the EasyIP
products.
4. In the list of equipment that the scan discovers, locate the EasyIP devices marked Not Set Up.
5. For each device, click the Not Set Up button and set the admin password on the device detail page that
opens.
The device now shows up as unlocked.
After the EasyIP devices have all been provisioned with admin passwords, you will be able to log in to the
administrative web interface for each one to complete system administration and other configuration tasks.
To access EasyIP devices' web interfaces from the Vaddio Deployment Tool:
Select the device's IP address from any page where it appears. See
Initial Access to the Web Interface
for
information about the warning messages that you will encounter the first time you access the device's web
interface.
14
Complete Manual for EasyIP Systems