CeilingVIEW HD-18 DocCAM Series
CeilingVIEW HD-18 DocCAM Manual - Document Number 342-0195 Rev. B
18 of 24
Compliance and CE Declaration of Conformity
Quick-Connect DVI/HDMI SR Interface
Compliance testing was performed to the following regulations:
x
FCC Part 15, Subpart B
Class A
x
ICES-003, Issue 4: 2004
Class A
x
European Standard EN 55022 A: 2006 + A1: 2007(CISPR 22:2005/A1:2005)
Class A
x
EMC Directive 2004/108/EC
Class A
FCC Part 15 Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15, Subpart B, of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his/her own
expense.
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This
device must accept any interference including interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by Vaddio can affect emission compliance and could void the
user’s authority to operate this equipment.
ICES-003 Compliance
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out
in the Radio Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n’emet pas de bruits radioélectriques dépassant les limites applicables aux
appareils numeriques de la classe A préscrites dans le Règlement sur le brouillage radioélectrique édicte par le
ministère des Communications du Canada.
European Compliance
This product has been evaluated for Electromagnetic Compatibility under the EMC Directive for Emissions and
Immunity and meets the requirements for a Class A digital device. In a domestic environment this product may
cause radio interference in which case the user may be required to take adequate measures.
Standard(s) To Which Conformity Is Declared:
EMC Directive 2004/108/EC
European Standard EN 55024: 1998 + Amendments A1: 2001 + A2: 2003
- Immunity
European Standard EN 55022 A: 2006+A1 2007 (CISPR 22:2005/A1:2005)
Conducted and Radiated Emissions
EN 61000-4-2
Electrostatic Discharge
EN 61000-4-3
Radiated Immunity
EN 61000-4-4
Electrical Fast Transients
EN 61000-4-5
Surge Immunity
EN 61000-4-6
Conducted Immunity
EN 61000-4-8
Power Frequency Magnetic Field
EN 61000-4-11
Voltage Dips, Interrupts and Fluctuations
To strictly comply with the EMC Directive, it is recommended that the supplied ferrite cylinders are applied to the cables as
described below:
x
One (1) Laird Technologies 28A2432-0A2 Clamp-on Ferrite Cylinder (If using the IR Forwarding Function, wrap IR forwarding LED wires
twice before screwing stripped wire ends to 3 conductor Molex 5.0mm Euro Jack)
x
Two (2) Laird Technologies 28A0640-0A2 Clamp-on Ferrite Cylinder (Clamp around 0.8" diameter shielded DVI cable at the Quick-
Connect end)
x
One (1) Laird Technologies HFA163090-0A2 Clamp-on Ferrite Cylinder (Clamp around 0.8" diameter shielded DVI Cable at the Monitor
end).
