CeilingVIEW 70 PTZ HideAway – Document 341- 075 Rev. D
Page 2 of 14
Read and understand all instructions before using. Do not operate
the camera if the camera has been dropped or damaged. In this
case, a Vaddio technician must examine the product before
operating. To reduce the risk of electric shock, do not immerse in
water or other liquids and avoid extremely humid conditions.
Carefully remove the device and all of the parts from the packaging.
Unpack and identify the following parts:
•
One (1) CeilingVIEW 70 PTZ Camera Module
•
One (1) White trim ring with IR sensor attached
•
One (1) Vaddio Quick-Connect Box
•
One (1) Sony RM-EV100 IR Remote Controller
•
One (1) Vaddio PowerRite 18VDC Power Supply
•
One (1) AC power cable for Power Supply
•
One (1) 12’ (4.57m) S-Video cable
•
One (1) 12’ (4.57m) Composite Video cable
•
Two (2) Adjustable ceiling tile support rails
•
One (1) RJ-45 to DB9 EZCamera™ serial control converter
•
Mounting
Hardware
•
Installation and User Guide (341-075 Rev. C)
UNPACKING
Use only the power supply provided with the CeilingVIEW 70 PTZ
HideAway camera system. Use of any unauthorized power supply will
void any and all warranties.
IMPORTANT
SAFEGAURDS
INSTALLATION
REMOVE the safety tape and then REMOVE the shipping hold-down
screw in the back of the camera module as indicated below (see Figure 2.
If power (over the Cat. 5 POWER/VIDEO cable) is connected to the
camera before the shipping hold-down screw is removed, serious
damage to the camera may result.
Remove
Sticker
Camera Top
Power/Video
RJ-45 Jack
Remove
Shipping
Screw
Camera Top
Figure 2:
Top of camera shown with safety tape (left) and location of
shipping hold down screw and Power/Video Jack (right).