Camera Commands Direct to Cameras Only
The following camera control commands must be sent directly to the camera, as they are not supported on
the other EasyIP devices:
n
camera ptz-position
n
camera led
n
camera icr
camera ptz-position
C
AMERA ONLY
Specifies multiple-axis movements to absolute positions.
Pan, tilt, and zoom may be specified in any order. All movements start simultaneously.
Synopsis
camera ptz-position pan <position> tilt <position> zoom <position> [no_wait]
Options
pan
<position>
<position> is a floating-point value approximately -
155.00 to 155.00 for the EasyIP 10; approximately -
150 to 150 for the EasyIP 20. Individual cameras
may have slightly more travel.
tilt
<position>
<position> is a floating-point value approximately -
30.0 to 93.0 for EasyIP 10, -30 to 90 for EasyIP 20.
Individual cameras may have slightly more travel.
zoom
<position>
<position> is a floating-point value 1.0 to 10.0 for
EasyIP 10, 1.0 to 20.0 for EasyIP 20.
no_wait
Optional – allows the command to return the
command prompt immediately, while the requested
camera movement is still in progress.
Examples
>
camera ptz-position pan -15 tilt 5 zoom 1.5 no_wait
OK
>
Moves the camera 15° left from its centerline and 5° up from horizontal, and zooms
to 1.5. The command prompt appears while the camera is still in motion.
120
Complete Manual for EasyIP Systems
