Access and Initial Device Set-Up Using the Vaddio Device Controller
The Vaddio Device Controller provides a shortcut to Vaddio products' web interfaces. Unlike the Vaddio
Deployment Tool, it does not need to be updated to support new products. For detailed instructions on
installation and use, refer to the Vaddio Device Controller's manual.
To complete the initial device set-up with the Vaddio Device Controller:
1. Be sure the touch-panel is installed on the same subnet as the products you need to work with – for
example, connect both to the same PoE+ switch.
2. Go to the touch-panel's Configuration page and select Scan. You will need to enter the Vaddio Device
Controller's PIN to access the Configuration page.
3. Locate the device you need to work with, and select Use.
4. Select Exit to leave the Configuration page and open the device's web interface.
Note
The first time you access a device at a specific IP address, the Vaddio Device Controller's screen may
remain blank for 20 seconds or more.
5. Complete the initial device set-up.
Getting the Camera's IP Address for Access via Browser
If you are not using the Vaddio Deployment Tool or the Vaddio Device Controller to locate and work with
the camera, you will need to know its IP address so you can browse to it.
If you know that your network does not automatically assign IP addresses,
skip this section: The
camera's address is 169.254.1.1. You will need to connect your computer's network port to the camera's
network port to do the initial device configuration and network configuration.
If you are not sure, or you know that your network automatically assigns IP addresses, you will need to be
able to view the camera's USB stream to get the IP address.
16
Complete Manual for the ConferenceSHOT AV Enterprise-Class Conferencing System
