vacuubrand VACUU-PURE 10, Инструкция по эксплуатации

Страница: 46 / 88

46 20901220_EN_VACUU·PURE 10_V1.6_060722
Commissioning (operation)
Dry vacuum pump
Dry the vacuum pump before changing media
The vacuum pump can be dried with the aspirated ambient air
without having to be separated from the application / equipment.
>
Use regeneration mode before changing the pumped medium
or the connected process, if pumped media can react with
each other in the vacuum pump or form deposits.
Dry the vacuum pump after process end
The vacuum pump can be dried with the aspirated ambient air.
>
Use the vacuum pump's regeneration mode after the end
of the process before stopping or switching off the vacuum
pump.
>
Allow the vacuum pump to continue running in regeneration
mode for about 30 minutes after the end of the process. This
reduces condensate and media residue in the vacuum pump
and thus also the risk of impairment to the vacuum pump by
the previously pumped media.
5.2.3 5.2.3 Autostart Autostart
The vacuum pump has an Autostart function. When the power
supply is switched off and then back on, the last active operating
state of the vacuum pump is automatically reactivated:
Operating status of the vacuum pump:
before discontinuation of
mains voltage
after restoration of mains voltage
Vacuum pump started Vacuum pump starts automatically
Vacuum pump stopped Vacuum pump stopped
Regeneration mode active
Regeneration mode automatically
active
>
Stop the vacuum pump with the stop button before switching
off the power switch or pulling the power plug.
5
This is how you will avoid an unintentional or unexpected
start of the vacuum pump the next time it is switched on.
Autostart
automatic restart of
the vacuum pump