vacuubrand VACUU-PURE 10, Инструкция по эксплуатации

Страница: 21 / 88

21 20901220_EN_VACUU·PURE 10_V1.6_060722
Safety information
Dangers due to vacuum pump Autostart
The vacuum pump has an Autostart function. When the power
supply is switched off and then back on, the last active operating
state of the vacuum pump is automatically reactivated, e.g.:
ƒ
after a power failure,
ƒ
after switching the vacuum pump off and on,
ƒ
after disconnecting and reconnecting the power plug.
An ongoing process starts automatically when the power supply
is disconnected and reconnected.
>
Check whether this function can be used safely with the
planned application.
>
Ensure that the automatic restart of the process does not
pose any danger to persons or equipment.
>
Take appropriate safety precautions (e.g., shut‑off valve, relay
switch, protection against restart) if an automatic restart of
the vacuum pump can lead to a dangerous situation.
>
The Autostart function can be deactivated via Modbus RTU
protocol; see separate manual for Modbus RTU description.
Hazards due to residual energy
After the vacuum pump has been switched off and disconnected
from the power supply, there may still be dangers due to residual
energy:
ƒ
Thermal energy: motor waste heat, compression heat.
>
Let the vacuum pump cool down before carrying out
maintenance work.
Hazards due to
residual energy
Hazards due to
automatic restart of
the vacuum pump
(Autostart)