Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999198 / 29/09/2009
•
The pumps are
not suitable
for pumping substances which may form
deposits
inside the pump. Deposits and condensate in the pump may lead to increased
temperatures even to the point of excessing the maximum permitted tempera-
tures!
• If there is a danger of formation of
deposits
in the pump chamber (check inlet
and outlet of the pump), inspect the pump chambers regularly and clean if neces-
sary.
• The pumps are
not suitable
for pumping dust and have
no approval
for opera-
tion below ground.
If pumping
different substances
, it is recommended to purge the pump with air or
inert gas prior to changing the pumped media in order to pump out residues and to
avoid reactions of the pumped substances with each other and with the pump ma-
terials.
Take into consideration interactions and chemical reactions of the pumped me-
dia.
Ensure that the materials of the
wetted part
s are compatible with the pumped
substances, see section ”Technical data”.
Safety during operation
➨
Adopt suitable measures to prevent the release of dangerous, toxic, explosive,
corrosive, noxious or polluting fluids, vapours and gases. In case install an ap
-
propriate collecting and disposal system and take protective action for pump and
environment.
➨
Prevent any part of the human body from coming into contact with vacuum.
➨
The user must take suitable precautions to prevent any formation of explosive
mixtures in the expansion chamber or at the outlet. In case of e.g. a diaphragm
crack, mechanically generated sparks, hot surfaces or static electricity may ignite
these mixtures. Use inert gas for gas ballast or venting if necessary.
➨
Potentially explosive mixtures at the outlet of the pump have to be drained ap-
propriately, sucked off or diluted with inert gas to non-explosive mixtures.
☞
Pay attention to the symbol ”hot surfaces” on the equipment. Adopt suitable
measures to prevent any danger arising from the formation of hot surfaces or
electric sparks. Provide a suitable protection against contact if necessary.
☞
Ensure that the exhaust pipeline is always free and pressureless.
☞
Pumping at
high inlet pressure
may lead to overpressure at the gas ballast
valve. Pumped gases or condensate might be pushed out in case the valve is
open. If an inert gas supply is connected, ensure that the inlet pipeline is not con-
taminated.
• Comply with applicable regulations when disposing of chemicals. Take into con
-
sideration that chemicals may be polluted.
Take adequate precautions to protect people from the effects of dangerous sub-
stances (chemicals, thermal decomposition products of fluoroelastomers), wear
appropriate safety-clothing and safety glasses.
• Use only
genuine spare parts and accessories.
Otherwise safety and perform-
ance of the equipment as well as the electromagnetic compatibility of the equip-
ment might be reduced.
Possibly the CE mark or the C/US conformity becomes void if not using genuine
spare parts.
NOTICE
