vacuubrand MD 12C NT VARIO o.C., Инструкция по эксплуатации

Страница: 19 / 92

19 20901544_E12C+16C_NT Vsel_V1.2_260922
Safety information
Risk of burns due to hot surfaces or overheating
Depending on operation conditions and ambient conditions dan ‑
gers due to hot surfaces may arise. Prevent any danger arising
from hot surfaces.
>
Avoid direct contact with the surface.
>
Use protection against accidental contact if the surface tem ‑
perature is regularly elevated.
>
Allow the vacuum pump to cool down before performing main ‑
tenance work.
>
Keep the electrical power cable away from hot surfaces.
>
Keep the electrical power cable away from heated surfaces.
The vacuum pump can be damaged due to overheating. Possi ‑
ble causes include insufficient air supply to the fan and failure to
maintain minimum distances.
>
When installing the device, ensure that there is a minimum
distance of 5 cm between the fan and adjacent parts (such as
the housing, walls, etc.).
>
Always ensure a sufficient air supply; if applicable, provide
external forced ventilation.
>
Place the device on a stable surface; a soft surface such as
foam rubber as a sound absorber can impair and block the air
supply.
>
Clean polluted ventilation slots.
>
Remove covers from the device before operating it.
>
Avoid excessive heat input due to hot process gases.
>
Observe the maximum admissible media temperature

see chapter: 8 .1 .1 Technical data on page 78 8 .1 .1 Technical data on page 78
.
Surface tempera‑
tures
Overheating