Vacon X5, Руководство пользователя

Страница: 111 / 140

X5 AC Drive User’s Manual Chapter 7: X5 Parameters
DPD00089A - 109 -
© 2009 Vacon Incorporated All Rights Reserved
955 Seq Count 1
956 Seq Count 2
957 Seq Count 3
958 Seq Count 4
959 Seq Count 5
960 Seq Count 6
961 Seq Count 7
962 Seq Count 8
963 Seq Count 9
964 Seq Count 10
965 Seq Count 11
966 Seq Count 12
967 Seq Count 13
968 Seq Count 14
969 Seq Count 15
970 Seq Count 16
971 Seq Count 17
972 Seq Count 18
973 Seq Count 19
974 Seq Count 20
975 Seq Count 21
976 Seq Count 22
977 Seq Count 23
978 Seq Count 24
979 Seq Count 25
Default: 0
Range: 0-65535
Level 2 (SEQ)
These parameters configure the time, number of pulses, or analog level of sequencer steps 1 through 25, respectively.
See
“Using the X5 Program Sequencer” on page 111 .
980 Seq Decision 1
981 Seq Decision 2
982 Seq Decision 3
983 Seq Decision 4
984 Seq Decision 5
Default: 00000 00000 00000
Range: n/a
Level 2 (SEQ)
These parameters each provide a 15-bit binary status display. See “Using the X5 Program Sequencer” on page 111 .
The following bits are used with each of these parameters:
Bit 0-4=State Decision Occurs
Bit 5-9=Destination State
Bit 10-15=Decision Condition
1500 Last Fault Read-Only
Range:n/a
Level: 2
This parameter , Last Fault , lists the most recent fault that occurred.
For more information, refer to Chapter 8, Troubleshooting, beginning on page 125 .
1527 9th Fault Read-Only
Range: n/a
Level: 2
This parameter , 9th Fault , lists the fault that occurred 1 before the last.
For more information, refer to Chapter 8, Troubleshooting, beginning on page 125 .
1554 8th Fault Read-Only
Range:n/a
Level: 2
This parameter , 8th Fault , lists the fault that occurred 2 before the last.
For more information, refer to Chapter 8, Troubleshooting, beginning on page 125 .
1581 7th Fault Read-Only
Range:n/a
Level: 2
Table 7-2: Description of X5 Parameters (Page 39 of 40)