V-ZUG AG
Industriestrasse 66, Postfach 59, 6301 Zug
T41 58 767 67 67, Fax +41 58 767 67 67
[email protected], www.vzug.com
Service manual
1036497-00-AE
1
Serial production
created
27.09.2017 waa
modified
28.09.2017 User Agent
checked
28.09.2017 asan
49 / 61
Service manual Platform 2014-2016, V-ZUG KT
1036497-00_ae gedruckt
3.
Unplug LED PCB.
4.
Replace LED PCB.
5.
Carefully plug LED PCB back in again.
Caution: Do not bend connector, otherwise contact
will be faulty!
6.
To put back LED PCB, reverse procedure.
7.3
Replacing sensor
F1 and F2 on display of operating unit
Always disconnect the refrigerator from the mains before working on
the electrical system!
Electrical safety (protection against contact) must be ensured by the
installation!
1.
Pin assignment (see section 5.2) Check ohm-
meter measurements for cooling compartment and
freezing compartment sensor.
If appliance has already been switched off for
longer, the temperature of the onboard sensor can
be queried (see section 0) and the room
temperature be determined.
2.
Pull holder out of its anchoring by hand.
