www.v-tuf.com
© V-TÜF
All V-TÜF Products should arrive to the consumer as ready to use immediately. Simply, plug in to the mains
outlet, then start the machine by moving the on/off switch to the ‘on’ position.
Motor Protection Filter & Exhaust Filter
The motor protection filter (21) is only accessible by removing the vacuum head. Lift the motor protection
filter up by the bracket. When replacing the motor protection filter make sure that it is pressed in position
tightly. The motor protection filter will protect the motors when vacuuming wet & dry material.
If the motor protection filter (fig 21) is used for wet suction. It must be stored outside the vacuum to dry
before being used again. If this is problem order a spare filter (21. Dust screen) and alternate the use. This
filter should be cleaned when it is dirty.
Motor Protection filters:
VTVS021 (FIG.21) Dust Screen (wire basket ordered separately) FLT02 WET only filter (optional) V VTSV087
Only for VT9000 or VTS8000 for WET ONLY use, please order the wet only filter (part number FLT02)
Change the exhaust filter at the same time as the motor protection filter. To do this, carefully remove the filter
retaining rings and put them to the side. Next pull the enforcement strips of the exhaust filter out of the
housing slot and remove the exhaust filter from the housing.
When reassembling, please ensure the exhaust filter is fitted correctly in the housing slots and the filter
retaining rings are installed correctly.
For DRY ONLY use, please order the dry only filter (part number V VTSV087)
The dry only filter can be used in conjunction with the dust screen. The dry only filter (VTSV086) fits over the
floating ball rack and is kept in place by the black cap lock (VTSV087)
Only use genuine V-TÜF replacements on the appliance. V-TUF will not accept responsibility for damage to
the machine or to the user due to insufficient levels of filtration for the application.
Accessories