www.v-tuf.com
© V-TÜF
Technical Information
Model
MAMMOTH 240
Capacity
90 Litres
Working Voltage
240 Volts
Power
3000 Watts
Function
Wet/Dry Vacuuming
Air Flow Rate
120 L/sec
Vacuum Suction
250 M/Bar
Cooling Mode
Circulating
Tank Diameter
Ø440mm
Height
1050mm
Accessories
Ø40mm
Power Cable
8 Meters
Safety Instructions
These instructions are for the user’s safety, and all users of the V-TÜF cleaning equipment should ensure to
have read this literature before using the machine.
Do not use with a damaged cable.
Do not run over the cable.
Should be inaccessible for children and pets.
Do not use in the presence of flammable gasses.
Do not clean up any hot material, e.g. ash.
Always turn off the machine, and then unplug it, before you service the machine.
Do NOT use this machine without the filter (21) as this is a health hazard and motor damage will
result.
The original motor protection filter (21) can be used for wet & dry suction, but it must be stored
outside the vacuum to dry before being used again. If this is problem order a spare filter (VTVS021)
and alternate the use. See Motor Protection Filter & Exhaust Filter
IMPORTANT! The filter (21) provided with this machine will be suitable for most applications;
however in some applications the filtration level will be insufficient. V-TUF will not accept
responsibility for damage to the machine or to the user due to insufficient levels of filtration for the
application. In an application where large volumes of water are being sucked up, we recommend you
use the wet-only filter
FLT02 (purchased separately). If it is an application where fine dust is being
sucked up, we recommend you use the dry-only filter V VTVS087 (purchased separately).
All repairs on V-TÜF products should be done by a V-TÜF service representative.
If the machine shuts down, be sure to turn off the machine and unplug it before troubleshooting.
For safety, the machine contains an electronic overload protection.
Always turn off and unplug the machine when it is not in use.
If any part of the appliance becomes damaged or fractured, it must be replaced by a V-TÜF engineer.
Operating Instructions