V-fit KP2071, Сборка и руководство пользователя

Страница: 19 / 24

Assembly
3
iii.
iv.
Assemble the Dual Action Handlebar Lower (6L/R) to Footplate Support Bar (5L/R) using
1 x M8 x 55mm Hex Bolt (30), 1 x M8 Flat Washers (31) and 1 x M8 Nylon Locknut (32)
for each side. Fit 1 x S14 Round Cap (23) to theoutside bolt head (30) and fit 1 x S13
Round Cap (57) to the inside Nylon Locknut as shown for each side.
Wavy Washer (64) onto each side of the Handlebar Upright Pivot Bar as shown.
Fit the correctly labelled (L or R) Dual Action Handlebar - Lower (6L / 6R) and secure in
place using 1 x M8 x 15mm Hex Bolt (24), 1 x M8 Spring Washer (52), 1 x M8 x 20mm Flat
Washer (25) and Cap the Hex Bolt (24) with 1 x S14 Round Cap (23) for each side.
i.
Connect the Footplate Bars (5 L/R ) to the Crankshaft (22) using 1 x Shouldered Bolt (38 L/R)
1 x M17 x 30mm Wavy Washer (62) throughthe Footplate Support Bar Pivot Bracket and into
the Crankshaft, then fit 1 x M13 Spring Washer (41) and 1 x M13 Nylon Locknut (42 L/R)
for
each side to secure the complete assembly. Cap the M13 Nylon Locknut with 1 x S19
Round Cap (43) for each side. See Note below.
Note
Ensure that the Shouldered
Bolts are fully tight before finally
securing the Nylon Locknuts.
One Bolt is supplied with a
RIGHT HAND THREAD for the
RIGHT HAND SIDE and must
be fitted by turning CLOCKWISE.
The other Bolt is supplied with a
LEFT HAND THREAD for the LEFT
HAND SIDE and must be fitted by
turning ANTI-CLOCKWISE.
ii.
Remove the 1 x M8 x 15mm Hex Bolt (24), 1 x M8 Spring Washer (52), 1 x M8 x 20mm
Flat Washer (25) from each side of the Handlebar Pivot Bar (27) Fit 1 x M20 x 30mm
Attach both Footplates (10L / 10R) to the Footplate Support Bars (5L / 5R)
using 2 x M10 x 45mm Hex Bolts (33), 2 x M10 Flat Washers (34) and 2 x M10
Nylon Locknuts (35) for each Footplate.
Align the Footplates and tighten the fitting Bolts and Nuts securely.
36
36
Page 1 9