3D Alpha+
User’s
Manual
35
6.1.2
Setup Wizard
This is the main screen that forward us to 6 or 7 step procedures of making the calibration
and settings of the device. For Wi-Fi Analytics Master there are 6 steps, whereas there are 7
steps for BLE projects.
6.1.2.1
Welcome to the Setup Wizard Screen
–
Step 1
In this page, Push Notification, Language and Wi-Fi/Bluetooth Analytics type should be
selected.
Language options are “Türkçe” and “English”.
The Push notification is selectable field that enable or disable these features:
Push Notification
enables the device to transmit iBeacon signals for mobile apps for
advertisements. This feature can be enabled only if the following steps are fulfilled:
•
Device must be connected to cloud.v-count.com over MQTT connection
•
Device must be defined as push notification enabled device on reporting tool.
If the device is an element of a Wi-Fi/Bluetooth Analytics system, then the questions must
be answered accordingly. The answers determine the type of engines that will run within the
device.
Note: Push notification and Bluetooth systems do not run and cannot be selected/activated
on the same device.
In this chapter Wi-Fi/BLE Analytics Master and Slave devices shall be examined.
The network status indicator is located at the system tools bar which is the upper bar of the
page.
Figure 35 Connection Status Indicator
These indicators show the connection status to the Remote Server. Please refer to Remote
Server topic.
On the bottom bar; information shown are:
•
Firmware version: first 2 digits of the version is firmware version
•
Hardware version: last 3 digits of the version is the hardware version
•
Date: Power on date the V-Count device.
