3D Alpha+
User’s
Manual
18
5.2
Setup Wizard
This is the main screen that forward us to 9 step procedures of making the calibration and
settings of the device.
5.2.1
Welcome to the Setup Wizard Screen
–
Step 1
In this page, Street Counting, Push Notification, Language and Wi-Fi/Bluetooth Analytics type
should be selected.
Language options are “Türkçe” and “English”
.
The Street Counting and Push notifications are selectable fields that enable or disable these
features:
Street Device
is a device that reports the incoming and outgoing counts by adding to a single
value. If this option is activated only one counting value is sent to remote server.
Push Notification
enables the device to transmit iBeacon signals for mobile apps for
advertisements. This feature can be enabled only if the following steps are fulfilled:
•
Device must be connected to cloud.v-count.com over MQTT connection
•
Device must be defined as push notification enabled device on reporting tool.
If the device is an element of a Wi-Fi/Bluetooth Analytics or Wi-Fi/Bluetooth Heatmap
system, then the questions must be answered accordingly. The answers determine the type
of engines that will run within the device.
Note: Push notification and Bluetooth systems do not run and cannot be selected/activated
on the same device.
From this page only, the engines of the Wi-Fi projects are activated. Configuration of these
properties are done on their own calibration interfaces. Please refer to corresponding User’s
Manuals for Wi-Fi devices.
The network status indicator is located at the system tools bar which is the upper bar of the
page.
Figure 14 Connection Status Indicator
These indicators show the connection status to the Remote Server. Please refer to Remote
Server topic.
On the bottom bar; information shown are:
•
Firmware version: first 2 digits of the version is firmware version
•
Hardware version: last 3 digits of the version is the hardware version
