15
15
15
Step 10
Install the hand control switch holder hook
Secure the hand control switch holder hook
(T) to a convenient location on the closest
appropriate wall by removing the protective
paper from the adhesive strip then adhere the
hook to the wall by applying pressure with
your fingers.
(SEE FIG. 10)
Step 11
Plug in the unit
Plug in the motor hoist (B) to the nearest 110 volt power outlet. You may wish
to use the power cord cable clamps (R) and the 2” wood screws (S) to secure
the power cord or extension cord (not provided) to the ceiling or wall.
Step 12
Test the unit
Press and hold the rocker switch on the hand
control to raise and lower the hook bar.
When the hook bar reaches the uppermost
travel point the ring above the cable hook will
trigger the limit switch ceasing upward
movement.
(SEE FIG 11)
Step 13
Using the key lock feature
To prevent unauthorized use the GG220 is equipped
with a key lock feature.
(SEE FIG. 12)
When the key is turned to the “OFF” position and
removed from the hand control switch the unit will not
function until the key is reinserted and turned to the
“ON” position.
FIG. 12
FIG. 10
FIG. 11
120
120
