Utimaco CryptoServer Gen2 Se Series, Руководство по эксплуатации, Страница: 21 / 28

Installation of the CryptoServer Driver Software
Page 21 of 28
uid = df000011 0c3d2a01 | =*
adm1 = 53653530 20202020 43533434 34383739 | Se50 CS444879
adm2 = 53656375 72697479 53657276 65720000 | SecurityServer
adm3 = 494e5354 414c4c45 44000000 00000000 | INSTALLED
If you cannot communicate with the CryptoServer Se, check that the PCIe plug-in card has
been installed correctly and check if the driver has been installed correctly. After that, repeat
the functional test.
If you still cannot communicate with the CryptoServer Se, please contact either the reseller
who supplied this CryptoServer Se or the Utimaco IS GmbH Customer Service team.
5.2.3 Updating the Driver
If you want to upgrade the driver, follow these steps:
1. Compile the new source code files into a kernel module called
cs2.ko
.
2. Copy this kernelmodule into the following directory:
/lib/modules/<kernel version>/kernel/drivers/pci
directory.
3. Restart the system.
5.2.4 Uninstalling the Driver
Perform the following commands to uninstall the driver:
1. Unload the Kernel module.
modprobe –r cs2
2. Determine the Kernel version using this command:
uname -r
3. Delete the
cs2.ko
kernel module, with this command:
rm /lib/modules/<kernel version>/kernel/drivers/pci/cs2.ko
4. Delete the
cs2
device file, with this command:
rm /dev/cs2
or
rm /lib/udev/devices/cs2
5. Delete the line
cs2
from this file:
/etc/modules
6. Shut down the Linux operating system before removing the CryptoServer Se.