Installation of the CryptoServer Driver Software
Page 20 of 28
To compile and install the driver for the Linux kernel please read and follow the instructions
in the README file on the product CD in the
…/Software/Linux/Driver
directory.
You should have root permissions for performing the CryptoServer driver
compilation/installation on a Linux operating system.
5.2.2
Performing a Functional Test
To check that the driver has been installed correctly and that the CryptoServer Se is working
properly, follow these steps:
1.
Open a command shell.
2.
Change to your home directory with the
cd
command.
3.
Go to the mount point for your CD-/DVD-ROM.
The system may already have created it for you:
cd /media/cdrom or cd /media/cdrom0
If not, create it yourself:
mkdir /media/cdrom
4.
Input the following command sequence to start the csadm administration tool from the
product CD to determine the status of the CryptoServer Se. In the following example we
assume that you are using a 32-bit Linux operating system.
cd Software/Linux/x86_32/Administration
export CRYPTOSERVER=/dev/cs2
./csadm GetState
If you are using a 64 bit Linux operating system please replace the path
cd Software/Linux/x86_32/Administration
in the example above by the path
cd Software/Linux/x86_64/Administration
.
If the driver has been installed correctly, and the CryptoServer Se is working properly, you
should see output that is similar to the following:
mode = Operational Mode
state = INITIALIZED (0x00100004)
temp = 36.1 [C]
alarm = OFF
bl_ver = 3.00.2.1 (Model: Se-Series)
Содержание CryptoServer Gen2 Se Series
Страница 1: ...CryptoServer PCIe Se Series Operating Manual...
Страница 4: ...Table of Contents Page 4 of 28...